The Alhambra star
Start with a floor of plain tiles. From the middle of every edge, draw two lines into each tile at the same angle to the edge, and stop each line where it meets its neighbour. The tiles drop away and stars appear, and every star point measures 180 degrees minus twice that angle. Slide the angle, or drag across the pattern, and watch the whole floor change. At 67.5 degrees every octagon holds an eight-point star.
On paper
- On squared paper, draw a square 24 squares wide. Cut off each corner with a slanted line from 7 squares along one side to 7 squares along the other. You now have an octagon.
- Mark the middle of all eight sides. On a flat side it is 12 squares along. On a slanted side it is 3½ squares across and 3½ squares up or down from either end.
- With a ruler, join every middle to the middle three sides further round, both ways. Eight straight lines cross inside the octagon.
- Check one with a protractor: each line meets its own side at 67.5 degrees, the angle this page opens on.
- Ink only the outer zigzag, where each line stops at the line coming from the next side; its inner corners sit 6 squares in from the flat sides. Rub out the rest. That is the eight-point star, and each point measures 45 degrees.
- To fill a page, draw more octagons side to side, every 24 squares. In the tilted squares left between them, carry each line straight on across the side until it meets another line, and four-point stars appear.
Why the points come out as they do: both lines cross an edge at the same angle, so inside one tile the two lines leaving a midpoint are 180 degrees minus twice the angle apart. That gap is the star point. At 67.5 degrees the points are 45 degrees, and in an octagon each line runs straight to the middle of the side three along, which is why a ruler alone can draw it. At 45 degrees the points are right angles and each octagon holds the star of two squares. The method is often called polygons in contact. E. H. Hankin described it in 1925.
Our design Alhambra Star is an eight-point star of Islamic strapwork in gold and lapis blue, around a jewelled medallion. It is inspired by the Alhambra. Printed to order on canvas, tees, hoodies, totes and all-over prints.
What is idealised: the tiles here are perfect regular polygons and every line is exact. The weave follows one simple rule, over at one crossing and under at the next, and the colours mark the star in each tile. None of it is traced from the Alhambra or from any historical panel.
© 2026 Abidance Technologies Inc. All rights reserved. The designs, this page and its code are ours; please link to it rather than copy it.